먹튀검증: Expectations vs. Reality

Cisco CCNP / BCMSN Exam Tutorial: Transforming The Energetic Router In HSRP

To move the BCMSN Test and receive your CCNP certification, you’ve received to understand HSRP within and out. Even though the Procedure and simple instructions of HSRP are quite simple, there are some essential details which can be simply overlooked but are important in acquiring HSRP to operate the way you need it to. Permit’s Examine utilizing the priority command effectively on equally the Test and in output networks.

A key benefit from the clearly show standby command may be the priority. The default is 100, as well as the router with the best precedence would be the Most important HSRP router. We’ll elevate the default precedence on R2 and find out the final results. R3 is currently the Energetic router and R2 the standby, so Enable’s raise the precedence on R2 and see what comes about.

R2(config)#interface ethernet0

R2(config-if)#standby five priority a hundred and fifty

R2#demonstrate standby

Ethernet0 – Team 5

Area condition is Standby, precedence a hundred and fifty

Hellotime 4 토토사이트 sec, holdtime 12 sec

Subsequent hi sent in 0.896

Virtual IP address is 172.12.23.ten configured

Energetic router is 172.twelve.23.3, precedence a hundred expires in 8.072

Standby router is local

1 condition modifications, past point out alter 00:fourteen:24

R2 now has a higher priority, but R3 remains to be the Energetic router. R2 will not likely just take more than given that the HSRP Major till R3 goes down – OR the preempt selection is configured on R2.

image

R2(config-if)#standby five priority 150 preempt

1d11h: %STANDBY-6-STATECHANGE: Ethernet0 Group five http://www.bbc.co.uk/search?q=토토사이트 state Standby -> Lively

Community point out is Energetic, precedence 150, could preempt

Following good day sent in 1.844

Energetic router is area

Standby router is 172.12.23.3 expires in 10.204

Virtual mac tackle is 0000.0c07.ac05

two condition alterations, very last point out adjust 00:00:thirteen

In just a couple seconds, a message seems the local condition has improved from standby to active. Exhibit standby confirms that R2, the neighborhood router, is now the active router – the key. R3 has become the standby. So if any person informs you that you've to take a router down to alter the Active router, they’re Improper – you simply need to utilize the preempt alternative about the standby priority command.

A different important Element of HSRP configurations is understanding the way to change the MAC address with the Digital router, together with interface monitoring. We’ll take a look at These attributes in another part of my HSRP tutorial!